Rebar is an indispensable material in the construction industry, and the shape of the rebar needs to be adjusted according to the demand to adapt to the project. Therefore, the steel bar bending machine is also a commonly used steel bar processing equipment.
Operating procedures for steel bar bending machine:
1. Check whether the mechanical properties are good, keep the workbench and bending machine table level; and prepare various mandrel tool blocks.
2. Install the mandrel, forming shaft, iron stop shaft, or variable stop frame according to the diameter of the processed steel bar and the requirements of the bending machine. The diameter of the mandrel should be 2.5 times the diameter of the steel bar.
3. Check the mandrel, the stopper and the turntable should be free from damage and cracks, the protective cover should be fastened and reliable, and it can only work after the empty machine is confirmed to be expected.
4. During operation, insert the end of the steel bar that needs to be bent into the gap provided by the turntable, fix the other end close to the fuselage, and press it tightly with your hands. Check that the fuselage is selected and installed on the side that blocks the steel bar before starting.
5. During the operation, it is strictly forbidden to replace the mandrel, change the angle, adjust the speed, etc., and do not refuel or remove it.
6. When bending steel bars, it is strictly forbidden to process steel bars that exceed the diameter, the number of roots, and the machine speed specified by the machine.
7. When bending high-hardness or low-alloy steel bars, the maximum limit diameter should be changed according to the regulations on the mechanical nameplate, and the corresponding mandrel should be changed.
8. It is strictly forbidden to stand on one side of the fuselage without a fixed side within the working radius of the bent steel bar. The bent semi-finished products should be stacked neatly, and the hooks must not face upwards.
9. When the turntable changes direction, it must be carried out after a complete stop.
10. After the operation, clean up the site, maintain the machine, and lock the box when the power is off.
security requirements
Safety requirements for manual bending
1. When bending thick steel bars with a horizontal wrench, pay attention to mastering the essentials of the operation. Stand firm on your heels, stand with your feet in a lunge, set up a board, pay attention to the panel saw, and firmly hold the steel bar at the mouth of the board. When bending, use force slowly and do not Excessive force prevents the board from being pulled off and the person is thrown down.
2. It is not allowed to bend thick steel bars at high places or on scaffolding to avoid falling from high places due to the pull-off during operation.
The operation method of the steel bar bending machine is also straightforward, but we must pay attention to safety when using it, because the pressure and pressure of this kind of equipment are tremendous, if you do not pay attention when using it, it is easy to cause physical injury.
However, Shaanxi Zhongtuo Mine Equipment Company's business scope is relatively broad, mining equipment, bridge equipment, road machinery, slope support products, and rescue tools, if you need them, you can contact us at any time.
WeChat/whatsapp:+86-13571973823
Fax:+86-02962322708
